TEXASLAWMAN
Lone Star Boars Owner
LSB TURKEY BUZZARD PRESERVATION SOCIETY
SUS VENATOR CLUB
LoneStarBoars Supporter
Many of you are still having problems setting up or configuring your thermal scopes hope this helps.
Your brightness may be set different not sure there could be several factors. The main thing is getting them to look the best.Great info. I have two of the units in the video. The adjustments required for each one to get a good picture is different. I adjusted them side by side at the same time too.
I think this will be helpful as most complaints on the Armasight ends up operator error and not set up properly.
Great info. I have two of the units in the video. The adjustments required for each one to get a good picture is different. I adjusted them side by side at the same time too.
Is this an updated firmware unit? Sounds like the auto gain control is taking over but hard to tell without seeing it.Todd, When I'm looking at the eyepiece on the Armasight Zeus 3-25x75 and turn the unit on the picture is very clear for a couple of seconds then the view gets grayed out some and the picture is not as clear. Any suggestions.
I am a new member. I just bought an Armasight Zeus 640. I am going to mount it on an ar platform 6.8spc. The ar is a rock river and has the military style fixed post sight on front with and above the gas block. Will this interfere with the thermal scope picture? Do I need to get another front sigh and gas block. Thank you for any help on ths matter>